How to use a variant sink depending on its input
조회 수: 1 (최근 30일)
이전 댓글 표시
I have a s-function and it has 6 outputs, the next step is to check is there a negtive in 6 outputs. If there is one negtive, the simulation should be stop. If there is not, the 6 outputs should be passed to next s-function to continue simulating. In this case, I choose a variant sink, one of the output connects to stop block and another connects to next s-function to continue simulating. The thing is how can I use variant sink depending on its input rather than a pre-defined varable.
The pic shows how I use the variant sink, but it has an error saying that both the h and y (two of the outputs of s-funtion) are not defined.
Thank you very much!
댓글 수: 0
채택된 답변
Fangjun Jiang
2018년 12월 13일
I think the "Variant Sink" block is un-necessary. If you want to stop the simulation when any of the output goes nagative, then you need to feed (or with some pre-process first) the output to the Stop block all the time. So the Stop block is constantly checking the value and stop the simulation when the condition is met. At the same time, also feed the output to the next s-function.
댓글 수: 6
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Model, Block, and Port Callbacks에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!