How to design a BAJA transmission system ?

조회 수: 3 (최근 30일)
Suraj Singh
Suraj Singh 2018년 3월 31일
댓글: Suraj Singh 2018년 4월 10일
I am a beginner, I made this (attached simulink design pic ) while learning from other videos and some basic knowledge of the data. Can you help me with this ? How can I improve this system. (It is baja designed transmission system, consisting a engine, cvt and single reduction gearbox with no differential). I don't know about r port in "Variable transmission ratio" block. Here's a simulink file attached.
  댓글 수: 3
Suraj Singh
Suraj Singh 2018년 3월 31일
Yeah. thanks !!!

댓글을 달려면 로그인하십시오.

답변 (1개)

Veer Alakshendra
Veer Alakshendra 2018년 4월 5일
편집: Veer Alakshendra 2018년 4월 5일
The input to r port is the gear ratio as the function of time. In your model you have used a signal builder block to represent gear ratio as a function of time which is a correct approach. Just make sure that you have taken the correct gear ratio.
Regards,
Veer
  댓글 수: 1
Suraj Singh
Suraj Singh 2018년 4월 10일
I have tried giving a contant value to the ratio (r port of VTR), but results are not showing up.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Simulink에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by