Change standard in HDL workflow adviser
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi,
I am working on HW/SW co-design this example with ZedBoard and FMCOMMS2/3/4, but I would like to have a control signal coming out from the Pmod port. (Whether JA/JB/JC/JD is fine.) I succeed in assign the signal to the Pmod port but the voltage is too low to drive my next stage mux, i.e. I need 3.3V from the Pmod but I can only get 2.5V from JA/JB port and 0.7V from JC/JD port.
I have asked the engineers from AVNET and they said the output voltage should reach 3.3V from Pmod. Besides, I have opened the bit file with my Vivado and I found that the iostandard at Pmod port is "lvcmos25", yet I could not change it into "lvcmos33".
In short, how could I do to level up my voltage coming out from Pmod with HDL workflow adviser?
Thank you very much for your help in advanced.
B.R.
Angie
댓글 수: 0
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 FPGA, ASIC, and SoC Development에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!