how to send a signal through a usb to a hardware device and make a LED glow
조회 수: 4 (최근 30일)
이전 댓글 표시
how to send a signal through a usb port to a hardware device and make a LED glow
답변 (1개)
Walter Roberson
2012년 4월 30일
USB is by definition a serial bus; any information sent over the bus is only present on the bus for a small fraction of a second. You thus cannot send and hold a signal via USB. Instead you would have to send data that the destination hardware interpreted as indicating the appropriate LED state.
There are suitable USB-compatible devices available: see http://www.mathworks.com/matlabcentral/answers/18366-how-to-send-a-signal-to-usb
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Data Acquisition Toolbox Supported Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!