필터 지우기
필터 지우기

how to send a signal through a usb to a hardware device and make a LED glow

조회 수: 4 (최근 30일)
mahendra kumar
mahendra kumar 2012년 4월 30일
how to send a signal through a usb port to a hardware device and make a LED glow

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Walter Roberson
Walter Roberson 2012년 4월 30일
USB is by definition a serial bus; any information sent over the bus is only present on the bus for a small fraction of a second. You thus cannot send and hold a signal via USB. Instead you would have to send data that the destination hardware interpreted as indicating the appropriate LED state.
There are suitable USB-compatible devices available: see http://www.mathworks.com/matlabcentral/answers/18366-how-to-send-a-signal-to-usb

카테고리

Help Center 및 File Exchange에서 Data Acquisition Toolbox Supported Hardware에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by