MATLAB is not showing/regenerating the figures upon pressing Run (F5)

Hi all,

When I open the program and load my script file and press run or F5, it will generate the figure. However, whenever I change something and run it again, the figure will not show up or regenerate. I can save, close, reopen, and run and it will give me a new figure. Sometimes I can work for several hours and this won't happen, or, (like right now), I have to restart the program every time I change something. And being a trial and error learner right now, that is getting very annoying.

Also note, this has happened to me on two computers while running different code. Just fyi.

Thanks,

Sam

Answer 1

[Samuel]

Someone else may be able to verify this, but would this error occur if you have a pause code, but you don't press 'enter' through all the pauses. I hope that makes sense.

Sam