How to refer the figure name in matlab
조회 수: 35 (최근 30일)
이전 댓글 표시
Hi, I would like to define a figure and then for that specific figure do some things. Foe example: I would like to vreat a digure say:
h1 = figure('units','normalized','outerposition',[0 0 1 1]);
and then I want for h1 to do for example:
subplot(1,3,1)
plot(N_vec,1./Err(N_vec),sprintf('*%c',colconds(loop)),'LineWidth',5)
hold on
plot(N_vec,1./ErrPV(N_vec),sprintf('*%c',colconds(loop+2)),'LineWidth',5)
hold on
xlabel('Population size','fontsize',20)
ylabel('Error^-2 ','fontsize',20)
legend('OLE','PV','OLE shuffled','PV shuffled','Location','northwest')
The thing is that from loop reasons, h1 is defined far from the above lines. and is not the current figure handel. So I want the above lines to refer specifically for h1. somethong like:
subplot('h1',1,3,1)
plot('h1',N_vec,1./Err(N_vec),sprintf('*%c',colconds(loop)),'LineWidth',5)
hold on
plot('h1',N_vec,1./ErrPV(N_vec),sprintf('*%c',colconds(loop+2)),'LineWidth',5)
hold on
xlabel('h1','Population size','fontsize',20)
ylabel('h1','Error^-2 ','fontsize',20)
legend('h1','OLE','PV','OLE shuffled','PV shuffled','Location','northwest')
But matlab gives error whenever i try to add the name h1 in the specific commands for the figure...
how do I refer the figure handel when I actully want to use it?
Thanks!!
댓글 수: 0
채택된 답변
추가 답변 (2개)
Preethi
2017년 1월 2일
hhello,
hope this helps. it sets figure with h1 handle as current figure.
set(groot,'CurrentFigure',h1);
댓글 수: 0
Niels
2017년 1월 2일
Hi,JazzMusic
did u try
figure(h1)
to set h1 the current figure before u use subplot?
figure(h1)
subplot(1,3,1)
plot(N_vec,1./Err(N_vec),sprintf('*%c',colconds(loop)),'LineWidth',5)
hold on
...
참고 항목
카테고리
Help Center 및 File Exchange에서 Subplots에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!