How can I use peak of a sine wave and use it in other part of the simulink model?

조회 수: 6 (최근 30일)
I want to use peak of the generated voltage and use that peak value as one of the input(constant) to my PLL block.
  댓글 수: 1
Abhisek Roy
Abhisek Roy 2016년 6월 3일
Hi Muhammed,
You can use a 'buffer' to store few samples and then find the peak of them. This peak will be the maximum of the values available in the buffer which may not be the peak of the signal. So you should store this value and again in the next iteration whatever output you get from the 'minmax' block, compare this value with the previous one to check which one is larger and store the larger one. After a few iterations, once the buffer is able to cover the whole range of the sinusoid you should get the peak of the incoming signal.
Regards, Abhisek

댓글을 달려면 로그인하십시오.

답변 (0개)


Help CenterFile Exchange에서 Descriptive Statistics에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by