How can I configure an XPC Target Digital Input (NI PCI-6621) only on falling/rising edges?
조회 수: 3 (최근 30일)
이전 댓글 표시
We use PCI-6221 cards from National Instruments which are fully supported for our xPC target environment. The card itself supports several methods for trigger generation according to the datasheet. However, I don't see any settings in Simulink when opening the PCI-6221 block. Is this feasible on hardware side?
댓글 수: 0
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Target Computer Setup에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!