xpc target error 8 102 1
조회 수: 6 (최근 30일)
이전 댓글 표시
I'm using Matlab 2014b. Sometimes I get the error 8 102 1, eaddrinuse and xpc says system halted. Mathworks support told me to increase communication timeout and said the issue was resolved, but it still happens after increasing timeout to 200. Anyone face this issue before? Are there any specific details about the error code?
Thanks, Harsh Karve
댓글 수: 3
답변 (1개)
TotallyNotABot
2017년 11월 22일
In case anyone still has the Error EADDRINUSE 8 102 1:
I solved it by activating "USB Support" in the Target Settings (slrtexplr -> "Your_Target" -> Properties).
If you're working with grafic mode enabled, you will only see "System halted". Without grafic mode you can check if this is your specific error.
Apparently simulink/your target machine doesn't like working without USB Support, even if there are no USB devices connected.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Multicore Processor Targets에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!