필터 지우기
필터 지우기

Is it possible to change the location/ position of the input/ output ports on a subsystem block?

조회 수: 119 (최근 30일)
I have a block with in1 in2, out1, out2 where out1 goes to the left and in1 comes in from the left and out2 goes out to the right and in2 comes in from the right. So, is it possible to switch the sides so that out1 and in1 are on one side and out2 and in2 are on the other? Not sure if this functionality has been implemented yet!
  댓글 수: 1
Ksenia Kolcio
Ksenia Kolcio 2015년 10월 31일
I would also like to be able to put some input ports on the right side of a subsystem block as well as output ports on the left side of the same subsystem block. Is this possible?

댓글을 달려면 로그인하십시오.

답변 (3개)

Prerana Ozarkar
Prerana Ozarkar 2019년 3월 5일
by using Flip/Rotate it is possible

Mumbere Samuel
Mumbere Samuel 2019년 12월 14일

men8th
men8th 2022년 11월 30일
If you draw a subsystem in a blank area on the canvas (left click + drag to highlight a square, then use the context menu to create a subsystem) it will be provided with an input port and an output port. It is possible to drag these ports around the permiter of the subsystem to change their position. It would appear that if you save the subsystem in a separate file as a reference subsystem it is no longer possible to reposition the ports.

카테고리

Help CenterFile Exchange에서 Subsystems에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by