Why does my Frequency Division Multiplexer demultiplex to negative and not the message signal?
조회 수: 9 (최근 30일)
이전 댓글 표시
Hi,
I'm working on a project that involves on the practice of communication techniques, designed in simulink. I'm trying to design a Frequency Divison Multiplexer that multiplex 3 modulated signals (AM modulated signals), then demultiplex to obtain the original signals back. However, when designing the demodulation circuit to remove the carrier signal, I'm not sure why its giving a negative amplitude and not the orginal message signals.
I'm confused if its my demodulation circuit or its just the characeristic of an Frequency Divison Multiplexer.
Note: From the multiplexer and modulation, there aren't any issues as its responding with the correct waveform of modulation and multiplex form.
Perameters:
Input 1 - 1volt, 100Hz message, 3kHz carrier, Sine
input 2 - 1volt, 150Hz message, 2.5Khz Carrier, Sine
input 3 - 1volt, 50Hz message, 1.2Khz Carrier, Sine
Saturation (for all) - 0 lower limit, 3 upper limit
Filter Desginer1 - Butterworth, Lowpass, filter order 3, pass band 3kHz
Filter Designer2 - Butterworth, Low pass, filter order 3, pass band 2.5kHz
Filter Designer3 - Butterworth, Low pass, filter order 3, pass band 1.2Khz
Constant (for all) = -0.3055
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1673166/image.png)
Figure 1: Circuit Diagram of Demultiplexer & Demodulation
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1673171/image.png)
Figure 2: Scope from the Demultiplex, saturation then the Low Pass Filter Output from order.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1673176/image.png)
Figure 2: scope output from the demodulation stage of the cirucit
댓글 수: 1
Yukthi S
2024년 5월 31일
The filters look fine to me though. Can you share your model for better debugging?
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Filter Design and Analysis에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!