variable duty ratio to a switch at different time intervals
조회 수: 5 (최근 30일)
이전 댓글 표시
I want to supply a gate pulse to an IGBT switch in DC-DC converter with a duty ratio of 40% from 0 to 2 seconds and 2 to 4 seconds with simulation time of 6 seconds and i want to disconnect the gate pulse to switch from 4 to 6 seconds. how to do this in simulink. The switching frequency of IGBT switch is 20 kHZ.
댓글 수: 6
Fangjun Jiang
2024년 4월 12일
@Manikanta Aditya, which Pulse Generator block are you referring to? I didn't find the place to "Define Variable Duty Ratio in Pulse Type Attributes".
Manikanta Aditya
2024년 4월 13일
I meant the Pulse Generator block in Simulink that allows defining a variable duty ratio based on time.
채택된 답변
Fangjun Jiang
2024년 4월 12일
I assume this is in Simulink. You can use an AND logic block or Product block to multiply two signals. One is the regular 40% duty cycle PWM all the time, the other is this On/Off signal based on pre-determined timing or based on event by other Simulink signal.
댓글 수: 3
Fangjun Jiang
2024년 4월 12일
You could use a Signal Builder block. Or use a Switch block, before t<4, pass the PWM. After that, switch to 0.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Switches and Breakers에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!