- TCP/IP Configuration: Make sure that your computer and the Rigol DL3031A are on the same network and verify their IP addresses
- Simulink Configuration: Check if the Simulink model and the TCP/IP Send or Receive block are added properly, and their parameters are set correctly.
- Block Configuration: Check if the TCP/IP Send or Receive block is setup to send or receive data in the format expected by the device (e.g., ASCII commands or binary data).
- Firewall and Security: Check your computer's firewall settings to ensure that they are not blocking the connection to the Rigol DL3031A.
How can I resolve the issue of connecting my Rigol DL3031A to Simulink via TCP/IP when I've already successfully connected it to MATLAB?
조회 수: 3 (최근 30일)
이전 댓글 표시
I would like to set up a communication session with the Rigol DL3031A via the TCP/IP Simulink block. I was able to connect my computer to the device with MATLAB; however, I am facing issues when trying to establish the connection through the Simulink model. Any assistance to resolve this issue would be highly appreciated.
댓글 수: 0
답변 (1개)
Ayush Anand
2023년 11월 26일
Hi Max,
I understand you are trying to setup a communication session with the Rigol DL3031A via TCP/IP Simulink block but are facing some issues. Here are a few general points you could check to try and resolve the same, focusing on “model parameters” and “model settings” in Simulink:
I hope this helps!
댓글 수: 0
참고 항목
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!