How can I setup the "FIR Rate Conversion HDL Optimized" block to give an evenly distributed output without the need for a FIFO?
조회 수: 1 (최근 30일)
이전 댓글 표시
We are using the "FIR Rate Conversion HDL Optimized" block to convert from a 4 kHz to a 5 kHz signal.
The block outputs 5 valid data points per 1 ms (I input an evenly distributed 4 kHz data set), but they are not evenly distributed to give a traditional 5 kHz signal.
In the examples the output is read into a FIFO and then read out at the final frequency to evenly distribute the data pulses.
Is there any way or correct setup to obtain an evenly distributed output, without the need for an additional FIFO in my system?
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1446437/image.jpeg)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1446442/image.png)
댓글 수: 0
채택된 답변
Bharath Venkataraman
2023년 8월 2일
This block provides output as soon as it is able to, so the output is not evenly spaced. You will need a small FIFO in this case to evenly space the output.
댓글 수: 3
Garrey Rice
2023년 8월 4일
The following example shows how to do what Bharath is suggesting. Hope this helps.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Optimization에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!