Add a Common Gear constraint to my simscape ,but the the positions of gears and shafts are changed. How to solve it?
조회 수: 1 (최근 30일)
이전 댓글 표시
I use solidworks to export simscape multibody,and generate all gear pump systems.
When I use Common Gear constraint to make two gears constrainted, the the positions of gears and shafts are changed.
Two gears and two shafts are not on the same plane.
How to solve it?
댓글 수: 0
답변 (1개)
Nathan Hardenberg
2023년 6월 6일
It seems like your solidworks model is not fully defined/connected. This allows the model to move. Under normal circumstances an error should be raised instead.
But what is the problem here (I'm having to guess a bit). Your follower-coodinate-systems of your revolute joints are most likely not in the same plane. To fix this you have to use a "Rigid Transform"-Block on one side of the "Common Gear Constraint". In there you have to put the offset of the two coordinate frames.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Multibody Modeling에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!