Error in Simulink with PV Array. Error in simulation Simscape
조회 수: 2 (최근 30일)
이전 댓글 표시
Dear MATLABmates:
I'm fairly new in MATLAB and I designed a Buck converter to work with a PV Array. The conections and all the design is OK but when I run it, I obtain the following error:
I don't know why it appears, it seems that all is okey but I obtain that error. The powergui is in continuous but when I change to discrete it appears too.
It's remarkable that when I put a capacitor in parallel with the PV module, it runs the simulation but I want to run it without it.
Please I need your help guys, it's for my final Bachelor thesis. Thank you in advance!
댓글 수: 1
Mohammed Shariq Ayjaz
2022년 11월 20일
편집: Mohammed Shariq Ayjaz
2022년 11월 20일
[Do this on your own risk - it's just a last minute option] Open the block of PV , inside it , place capacitor parallel (i.e wherever you are not getting that error). Also, for safety make it tiny in size & hide it under some block so that if you will be safe even if your supervisor/judge asks to open the pv block.
답변 (1개)
Joel Van Sickel
2022년 11월 21일
If it works in continuous but fails in discrete, it is likely your time step is too large. You should be able to get it to work with a smaller time step. If that doesn't work, I'd ask that you share your model so that a deeper look can be taken.
댓글 수: 0
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Block Libraries에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!