Audio Pitch Manipulation Through Time
조회 수: 2 (최근 30일)
이전 댓글 표시
Dear Community, I recently discovered the possibility to manipulate the pitch of a sine wave by changing the time interval values before the creation (y=sin(2*pi*f*t)) For my new project I would need to manipulate the pitch of an imported audio file in the same way but I can not figure out how to achieve it. Any help is very much appreciated! Thanks!
댓글 수: 0
채택된 답변
Star Strider
2022년 9월 30일
댓글 수: 6
Star Strider
2022년 10월 3일
편집: Star Strider
2022년 10월 3일
As always, my pleasure!
EDIT — (3 Oct 2022 at 15:12)
Thinking about this further, while the sampling frequency must be kept constant, the intervals in the time vector used to create a specific sound does not.
Example —
Fs = 44100;
t = linspace(0, 3*Fs-1, 3*Fs).'/Fs; % Original Time Vector (Column Vector)
s = @(t) sin(2*pi*t*1000); % Original Sound Function
ts = 0.75*exp(-(t-1.5).^2*25); % 'Warped' Time Vector
th = hypot(t,ts); % Sampling Times Of 'Warped' Time Vector
figure
plot(t,th)
grid
xlabel('Time')
ylabel('Warped Time')
figure
plot(t,s(t))
grid
xlabel('Time')
ylabel('Amplitude')
title('Original Tone')
figure
plot(t,s(th))
grid
xlabel('Time')
ylabel('Amplitude')
title('''Warped'' Tone')
sound(s(t),Fs)
pause(3)
sound(s(th),Fs)
The sampling intervals must be monotonically increasing, and the sound function assumes that they are regularly-spaced, so varying the time intervals (created by taking the hypotenuse of the ‘warped’ time vector) used to calculate the tone frequency causes the frequency to change when the sound is played back. This example uses a Gaussian function to warp the time vector, however any continuouis function will likely work. (Discontinuous functions would create a ‘popping’ sound at the discontinuities, so I do not recommend them.)
.
추가 답변 (1개)
jibrahim
2022년 10월 20일
%Read in an audio file and listen to it.
[audioIn,fs] = audioread('Counting-16-44p1-mono-15secs.wav');
sound(audioIn,fs)
%Increase the pitch by 3 semitones and listen to the result.
nsemitones = 3;
audioOut = shiftPitch(audioIn,nsemitones);
sound(audioOut,fs)
%Decrease the pitch of the original audio by 3 semitones and listen to the result.
nsemitones = -3;
audioOut = shiftPitch(audioIn,nsemitones);
sound(audioOut,fs)
댓글 수: 1
참고 항목
카테고리
Help Center 및 File Exchange에서 Audio I/O and Waveform Generation에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!