How to control the cart position in inverted pendulum using PID controller?
조회 수: 1 (최근 30일)
이전 댓글 표시
I am following the above instructions as you can see at the bottom it is mentioned the cart moves negative direction with approximately constant velocity. I would like to move the cart in both directions to balance the pendulum. Please advise.
댓글 수: 0
답변 (1개)
Arkadiy Turevskiy
2015년 2월 25일
To control both the position and the angle, you would need to set up a little bit more involved controller architecture. Take a look at this example that shows one way of doing that and tuning the controller.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 PID Controller Tuning에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!