How to simulate a DAB open loop in Simscape?
조회 수: 15 (최근 30일)
이전 댓글 표시
I am trying to simulate a DAB converter in simscape so that I can run linear analysis on it. I'm learning to use this linear analysis tool for control system design. I have not really used simscape before and am finding a bit difficulty using the solver blocks. For this current model, I am trying to simulate the model shown in picture 1.
It only simulates if i have a ground(electrical reference block) connected on each side of the transformer. If not, I get an error as shwon in picture 2.
When I put ground on both sides, I get 0 as my output. So, can someone help me find the mistake I'm doing here? Any suggestion/comment will definetely of good help.
Thank you!
댓글 수: 0
답변 (1개)
Sabin
2022년 12월 15일
Hi,
An electrical reference is required each side of the transformer. The output 0 might be related to the way you define gate signals, or the parameterization of the components used in the model. I suggest looking at the following example in Simscape electrical:
I hope this helps.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Troubleshooting에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!