Aerospace Blockset: 6DoF (Euler Angles) How to use with a CG not located at the origin?
조회 수: 5 (최근 30일)
이전 댓글 표시
In the documentation for the 6DoF (Euler Angles) block, it says that the center of gravity (CG) is located at the origin of the body-fixed coordinate frame. In other words, CG = [0;0;0]. Is it posible to use a CG that is not located at the origin of the body frame? We are simulating a vehicle where the CG = [0; 0; Zcg]. How may we use this Simulink block for the case where the CG of the vehicle is not located at the origin of the body reference frame?
댓글 수: 0
답변 (1개)
Nirupama
2024년 1월 25일
Yes as you have mentioned above, in the documentation for 6DOF (Euler Angles) block it is mentioned that the origin of the body-fixed coordinate frame is the center of gravity of the body. I looked at the parameters of this block in Simulink. Unfortunately, there is no option to change the origin of the body-fixed coordinate frame in the 6DOF (Euler Angles) block.
Documentation link: https://www.mathworks.com/help/aeroblks/6dofeulerangles.html#mw_2f302a65-767b-4836-81d3-8d9423421b84
Regards,
Nirupama
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Aerospace Applications에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!