Modelling a voltage controlled current source
조회 수: 6 (최근 30일)
이전 댓글 표시
Hi!
I have a school project, where i need to simulate the blindig of protecion and sympathetic tripping defense problems. I'd like to model a current source that responds to the voltage drop caused by a fault. I'm using the controlled current source block for it. The constant block has the effective power value which gets divided by the rms value of the voltage so it should give me the current. My problem is that when i connect this block to my circuit it doesnt do anything. I'd like to ask what is the problem with my model?
답변 (1개)
Joel Van Sickel
2022년 6월 13일
This looks like it creates an algebraic loop. It's easier to do this type of modelling using simcape: https://www.mathworks.com/learn/tutorials/circuit-simulation-onramp.html
and use this block to model a dynamic load: https://www.mathworks.com/help/physmod/sps/ref/dynamicload.html
Regards,
Joel
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Sensors에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!