OBSERVING SIGNAL GENERATOR OUTPUT AT HIGH FREQUENCY IN SIMULINK
조회 수: 8 (최근 30일)
이전 댓글 표시
Hi, In simulink,when i use signal generator at low frequency(egs:1 rad/sec) and observe the sine wave in a scope,my output is correct.But when the frequency is increased(egs:10 rasd/sec),the output is not correct.why is it so?Can somebody help me.
댓글 수: 0
채택된 답변
Orion
2014년 11월 18일
Hi,
My guess is that you forget to change your simulation parameters.
In the toolbar :
Simulation -> Model Configuration Parameters.
change the solver to fixed-step, and put a small sample time to force Simulink to simulate at a desired rate.
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Sources에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!