making a data series with 2 or 3 discrete pulse, rest are zero
조회 수: 1 (최근 30일)
이전 댓글 표시
Hello, I am new to matlab. I want to prepare a data series of say 1024, with 2 or 3 sharp pulses at discrete positions. I want rest points to be zero (preferable) or very small values, so that I can really identify the pulses. Later, if I want to add a normally distributed random noise, how I can do that. thanks a lot in advance. regards. asim
댓글 수: 0
답변 (1개)
Fangjun Jiang
2011년 8월 22일
Series=zeros(1024,1);
RandPos=[10,13,50];
PulseHeight=2;
Series(RandPos)=PulseHeight;
Noise=rand(1024,1);
Signal=Series+Noise;
plot(Signal);
댓글 수: 6
Fangjun Jiang
2011년 8월 22일
All right,the point here is to show you the method, not give you the complete solution. From the above example, I hope you start to understand how easy MATLAB can enable you to do this. To define time, t=0:0.1:10.24. To generate a unit sine wave with frequency f, f=2; Data=sin(2*pi*t); You can use the same method to generate the pulse signal with high frequency and high magnitude. Then to add them together at a certain time spot, you can use for example: Data(51:60)=Data(51:60)+PulseSignal(1:10). Note that your sample time is 0.1sec, which means 10Hz, you can't really represent any signal with frequency high than 5Hz
참고 항목
카테고리
Help Center 및 File Exchange에서 Waveform Generation에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!