how to give three inputs to a scope block in simulink ?
조회 수: 12 (최근 30일)
이전 댓글 표시
how i can give multiple inputs a scope block?
댓글 수: 0
답변 (1개)
Mischa Kim
2014년 3월 27일
편집: Mischa Kim
2014년 3월 27일
Kishore, simply use a multiplexer (Mux) block (in > Commonly Used Blocks) to combine the signals into one vector signal. The vector signal then connects to the Scope. By opening (double-click) the block you can define the number of signals to be combined.
댓글 수: 1
John Kozell
2020년 4월 1일
Does this still work in R2020a? When I try to add a mux in front of a scope block, i get the following error:
Connecting the output port to a Bus Creator or Mux block '.../Mux' is not supported. To log or inspect these signals, consider streaming them to the Simulation Data Inspector or use one observation block per signal.
I'm just trying to observe 2 "entities departed" (d) statistics from 2 different queues - on the same graph.
Thanks
-John
참고 항목
카테고리
Help Center 및 File Exchange에서 View and Analyze Simulation Results에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!