Current-Controlled Voltage Source

R2026b

Linear current-controlled voltage source

• 

Current-Controlled Voltage Source block

To add a block to a model, double-click the canvas and start typing the block name. Then, select the block from the list.

Libraries:
Simscape / Foundation Library / Electrical / Electrical Sources

Description

The Current-Controlled Voltage Source block models a linear current-controlled voltage source, described with the equation

$$V=K·I1$$

where:

• V is the output voltage.

• K is the transresistance.

• I1 is the control current.

The + and - ports on the left side of the block are the control ports. To use the block, connect the control ports to the control current source. The arrow between these ports indicates the positive direction of the control current flow. The two ports on the right side of the block are the output ports. They generate the output voltage, with the polarity indicated by the + and – signs on the block icon.

Variables

To set the priority and initial target values for the block variables prior to simulation, use the Initial Targets section in the block dialog box or Property Inspector. For more information, see Set Priority and Initial Target for Block Variables.

Nominal values provide a way to specify the expected magnitude of a variable in a model. Using system scaling based on nominal values increases the simulation robustness. Nominal values can come from different sources, one of which is the Nominal Values section in the block dialog box or Property Inspector. For more information, see Modify Nominal Values for a Block Variable.

Ports

Conserving

+ — Positive control terminal

electrical

Electrical conserving port associated with the positive control terminal.

- — Negative control terminal

electrical

Electrical conserving port associated with the negative control terminal.

+ (p2) — Output voltage positive terminal

electrical

Electrical conserving port associated with the output voltage positive terminal.

The port name is not visible in the block icon, but you can see this name in the underlying source file by clicking the Source code link in the Description tab of the block dialog box.

- (n2) — Output voltage negative terminal

electrical

Electrical conserving port associated with the output voltage negative terminal.

The port name is not visible in the block icon, but you can see this name in the underlying source file by clicking the Source code link in the Description tab of the block dialog box.

Parameters

Transresistance K — Ratio of voltage to control current

1 Ohm (default) | scalar

Ratio of the voltage between the two output terminals to the current passing between the two control terminals.

Extended Capabilities

C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.

Version History

Introduced in R2007a