V5 GPS Sensor

Read position and orientation

Since R2022b

expand all in page

Add-On Required: This feature requires the Simulink Coder Support Package for VEX EDR V5 Robot Brain add-on.

  • Differential (Tank) Drive block

Libraries:
Simulink Coder Support Package for VEX EDR V5 Robot Brain / Sensors

Description

The GPS Sensor block reads position and orientation from the VEX V5 GPS Sensor connected to the robot.

The block outputs pose as a 3-by-1 vector representing X, Y coordinates and θ heading. Additionally, it outputs an estimate of position error.

This block also allows you to visualize the sensor and robot configuration.

Ports

Output

expand all

Pose specified as a three-element vector of [x y θ], where x and y corresponds to position and θ corresponds to the orientation angle. θ is positive clockwise and its range is 0-360 degrees.

Data Types: double

This port outputs the estimation of position error in meters.

Dependencies

Data Types: double

The Euler port outputs yaw, pitch, and roll angles as a 3-by-1 vector in the z-y-x sequence.

Dependencies

To enable this port select the Euler angles (deg) parameter.

Data Types: double

The Accel port outputs acceleration (or specific force) in x, y, and z order as a 3-by-1 vector. The Acceleration is measured in m/s2.

Dependencies

To enable this port select the Acceleration (m/s^2) parameter.

Data Types: double

The Ang rate port outputs the angle of rotation per second about the x-, y-, and z- axes of the sensor as a 3-by-1 vector. The angular rate is measured in deg/s.

Dependencies

To enable this port select the Angular rate (deg/s) parameter.

Data Types: double

Parameters

expand all

Select the smart port on the V5 robot to which the VEX V5 GPS sensor is connected. There are 21 smart ports on the V5 robot.

Assign a unique smart port for each block in the model. If you use multiple GPS Sensor blocks with the same port, then the last executed GPS Sensor block sets the sensor parameters.

Click Visualize to view the GPS mounting position and initial pose of the robot in a graph. A sample screen is shown below.

GPS Mounting Location (on robot)

Set the x-axis position coordinate of GPS sensor relative to the robot's center

Set the y-axis position coordinate of GPS sensor relative to the robot's center.

Set the heading of GPS sensor relative to the robot's forward axis. Heading is measured clockwise. If the GPS sensor is in forward direction of robot, this parameter will be 0.

Initial Robot pose

These parameters help the GPS sensor initialize the outputs when field strips are not clearly visible. There is no need to set these parameters if field strips are visible and the sensor is not too close to the strips.

Set the x-axis position coordinate of initial robot location on V5 Field. 0 corresponds to the center of the field.

Set the y-axis position coordinate of initial robot location on V5 Field. 0 corresponds to the center of the field.

Set the initial heading of robot relative to the field. Heading is measured clockwise. If the robot is perfectly aligned against the field code strip number 4, heading will be 0.

Additional Outputs

Select the Euler angles (deg) parameter to enable Eulerport. For more information, see Euler.

Select the Acceleration (m/s^2) parameter to enable Accel port. For more information on the Accel port, see Accel.

Select the Angular rate (deg/s) parameter to enable Ang rate port. For more information on the Ang rate port, see Ang rate.

Extended Capabilities

expand all

C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.

Version History

Introduced in R2022b