네트워크
R2026bTCP(Transmission Control Protocol)는 클라이언트/서버 패킷 기반 프로토콜이고 UDP(Universal Datagram Protocol)는 이더넷 보드를 물리 계층으로 사용하는 패킷 기반 프로토콜입니다. 각 패킷에는 응용 계층에서 제공하는 바이트가 포함되어 있습니다. 호스트 컴퓨터에서 실행 중인 실시간 애플리케이션에서 이러한 프로토콜을 사용하여 데이터를 전송할 수 있습니다.
블록
 | TCP/IP Receive | Receive data over TCP/IP network from remote host |
 | TCP/IP Send | Send data over TCP/IP network to another remote host |
 | UDP Receive | Receive data over UDP network from remote host |
 | UDP Send | Send data over UDP network to remote host |
도움말 항목
- Connect Arduino Ethernet Shield to Arduino Hardware
Follow the steps to connect the Arduino® Ethernet Shield to an Arduino hardware board.
- Configure Network Settings for Arduino Ethernet Shield
Follow the steps to configure the network settings for Arduino Ethernet Shield.
- Configure Model to Run in External Mode over Ethernet
Follow the steps to simulate model in external mode using over the TCP/IP network.
추천 예제
Get Started with Wi-Fi on Arduino Hardware
Use Simulink® Support Package for Arduino® hardware to receive and send TCP/IP or UDP messages over Wi-Fi® using Arduino boards.
Use Ethernet Shield with Arduino Hardware
Use Simulink® Support Package for Arduino® hardware to receive and send TCP/IP or UDP messages using an Arduino with an Ethernet Shield.
Control Brightness of Arduino Onboard LED from Android Device
Use the Simulink® Support Package for Arduino® Hardware to control brightness of an LED on an Arduino board using an Android® device.
