이 페이지는 기계 번역을 사용하여 번역되었습니다. 최신 내용을 영문으로 보려면 여기를 클릭하십시오.
모델링
R2025b하드웨어 연결을 위한 Simulink® 모델을 준비하고, 하드웨어 프로토콜 지원을 위한 블록을 추가하고, 다양한 응용 사례를 다루는 예제를 참조합니다.
블록
 | Analog Input | Measure the voltage of analog input pin |
 | Analog Output | Send analog output signal to DAC0_OUT pin |
 | Digital Read | Read the logical value of digital input pin |
 | Digital Write | Set the logical value of a digital output pin |
 | FXOS8700 6-Axes Sensor | Get measurement of linear acceleration and magnetic field along the X, Y, and Z axes of the FXOS8700 6-Axes chip |
 | I2C Controller Read | Read data from I2C peripheral device or I2C peripheral device register |
 | I2C Controller Write | Write data to I2C peripheral device or I2C peripheral device register |
 | Push Button | Read logical state of Push button |
 | PWM Output | Generate pulse waveform on specified output pin |
 | Quadrature Encoder | Measure rotation of encoder in ticks |
 | Serial Receive | Read data from UART port |
 | Serial Transmit | Send serial data to UART port |
 | TCP Receive | Receive data over TCP/IP network from remote host |
 | TCP Send | Send data over TCP/IP network to remote host |
 | UDP Receive | Receive UDP message from UDP host |
 | UDP Send | Send UDP message to UDP host |
도움말 항목
- Tune Parameters and Monitor Data in Model Running on Target Hardware
Tune parameters and monitor a model running on your target hardware.
- Exchange Ethernet Data by Using UDP Blocks
The use of UDP blocks to exchange data between the development computer and the target hardware via Ethernet communication
- Model Configuration Parameters for NXP FRDM-K64F Board
Parameter and configuration options for creating and running applications on the target hardware.
- Log Signals on SD Card
Log signals from Simulink models on an SD card mounted on the target hardware.
- Getting Started with Simulink Coder Support Package for NXP FRDM-K64F Board
This example shows you how to use Simulink® Coder™ Support Package for NXP FRDM-K64F Board to run Simulink models on a FRDM-K64F board.
- Code Verification and Validation with External Mode
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-K64F for code verification and validation using External mode.
- Read Temperature from an NXP FXOS8700CQ Sensor Available on NXP FRDM-K64F Hardware
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-K64F Board to configure and read temperature from an NXP FXOS8700CQ sensor, which is a I2C-based sensor.
- Exchanging Ethernet Data with the FRDM K64F Hardware
This example shows you how to use Simulink® Coder™ Support Package for NXP FRDM-K64F Board to send and receive UDP data.
- MAT-file Logging on an SD Card on NXP FRDM-K64F Board
This example shows you how to perform MAT-file logging from a Simulink® model on a Micro SD card mounted on NXP™ FRDM-K64F board.
