무선통신 관리
무선통신 신호를 송신하고 수신하기 전에, 먼저 무선통신 하드웨어 파라미터를 적용하고 무선통신 속성을 조정하십시오.
함수
capture | Capture RF signal data using USRP radio (R2023b 이후) |
setsdruip | Set IP address for USRP radio |
info | USRP radio information |
referenceLockedStatus | Lock status of USRP radio to 10 MHz clock signal (R2021a 이후) |
gpsLockedStatus | Lock status of GPSDO to GPS constellation (R2021a 이후) |
getRadioTime | Get current USRP radio time (R2023b 이후) |
객체
comm.SDRuReceiver | Receive data from USRP device |
comm.SDRuTransmitter | Send data to USRP device |
블록
SDRu Receiver | Receive data from USRP device |
SDRu Transmitter | Send data to USRP device |
도움말 항목
- USRP Radio Configuration
Determine which USRP™ radio products to use.
- Single Channel Input and Output Operations
Single input single output (SISO) operations use one transceiver only.
- Multiple Channel Input and Output Operations
Multiple Input Multiple Output (MIMO) operations use multiple transceiver chains.
- Transmit and Receive Using External Clock
An external clock enables you to synchronize the radio with an external clock generator.
- Check USRP Radio Connection
Check radio connection to SDRu blocks and System objects.
- Run in Offline Mode
Running simulations when no radio is connected.
- Query and Set IP Addresses
You can query and set IP address of connected radios.
- Detect Underruns and Overruns
To detect underruns and overruns, use the lost sample indicator.
- Burst-Mode Buffering
To achieve real time performance, enable burst mode.
- Data Frame Lengths
Set data frame length in receiver blocks or receiver System objects.
- Change Transport Data Rate
Set the transport data rate in blocks or System objects.
- Desired Versus Actual Parameter Values
Actual parameter values can vary from your desired setting.
- Supported Data Types
Supported data types for SDRu blocks and System objects.
문제 해결
Describes the most common errors encountered with Communications Toolbox™ Support Package for USRP Radio and how to fix them.