하드웨어-소프트웨어 공동 설계
Communications Toolbox™ Support Package for USRP Embedded Series Radio를 사용하면 Simulink®에서 SDR 알고리즘을 설계한 다음 USRP 임베디드 시리즈 라디오에 대한 설계 프로토타입을 만들 수 있습니다. 기본 Zynq® SoC(System on Chip)의 ARM® 프로세서와 FPGA 패브릭 간에 분할된 하드웨어-소프트웨어(HW/SW) 공동 설계 구현을 배포하거나, FPGA 패브릭만 타깃으로 하는 설계의 프로토타입을 만들 수 있습니다. 이 워크플로는 Simulink에서만 사용할 수 있습니다.
함수
sdrdev | Create radio object for interfacing with USRP embedded series radio hardware |
블록
| E3xx Receiver | Receive data from USRP E3xx radio hardware |
| E3xx Transmitter | Send data to USRP E3xx radio hardware |
도움말 항목
- Hardware-Software Co-Design Overview
Learn the basics of the hardware-software co-design feature in this support package and its software requirements.
- Installation for Hardware-Software Co-Design
Install and configure additional support packages and third-party tools required by hardware-software co-design workflow.
- Hardware-Software Co-Design Workflow
Deploy partitioned hardware-software co-design implementations for SDR algorithms.
- Guidelines for Configuring the Software Interface Model
Configure your model for continuous and packet-based transmission and reception.
- System Timing
Explore ARM processor scheduler options for the software interface model.
- FPGA Targeting Workflow
Prototype SDR algorithms on the FPGA fabric only.
문제 해결
Troubleshooting Hardware-Software Co-Design
Resolve issues encountered while using the hardware-software co-design workflow.
추천 예제
HW/SW Co-Design with AXI4-Stream Using USRP E3xx
Deploy a hardware-software co-design implementation of a waveform transmitter and receiver using AXI4-Stream.
Target QPSK Transmitter and Receiver to USRP E3xx Using HW/SW Co-Design Workflow
Implement QPSK transmitter and receiver algorithm partitioned across the ARM and the FPGA fabric.
Target ADS-B Airplane Tracker Using USRP E3xx and HW/SW Co-Design Workflow
Partition ADS-B receive functionality across the ARM and the FPGA fabric.
