답변 있음
How can I do feedback torque control of a permanent magnet synchronous motor (PMSM)?
The folowing example is doing PMSM torque control: https://www.mathworks.com/help/sps/ug/ipmsm-torque-control.html An example ...

2개월 전 | 1

| 수락됨

답변 있음
The unit of torque constant Nm/Apeak or Nm/Arms of PMSM parameters
The torque constant assumes per peak value.

2개월 전 | 0

답변 있음
What is the tail time of the IGBT/DIODE block in Simulink?
The IGBT tail current can be simulated with the N-Channel IGBT in Simscape Electrical. The tail current can be controlled by adj...

2개월 전 | 0

답변 있음
Design of sliding mode controller
The question is rather vague. I would start with something like hysteresis-based sliding mode control (SMC) first. Check Simscap...

2개월 전 | 0

답변 있음
Connecting optocoupler to buck converter in simulink
Most likely the blocks are from two different technologies, i.e., Simscape technology and Specialized Power Systems. It is not p...

2개월 전 | 0

답변 있음
Hello How can I design controller by pole placement method using matlab? parameters are D = 0.6, fs = 20 kHz, L = 200 μH, C = 50 μF, Vout = Vc = 300 V, Pin = Pout = 1.5 KW, R = 60 Ω. It is for boost mode of Bidirectional Full Bridge DC-DC Converter
First a model for control design is needed. Then the function 'place' from Control Systems Toolbox can be used: https://mathwor...

2개월 전 | 0

답변 있음
Is it possible to connect components of different libraries together?
There are equivalent blocks in Simscape electrical in both Simscape technology and Specialized Power Systems. It is better to us...

2개월 전 | 0

답변 있음
how to convert Resolver output to digital in simulink ?
It is possible to use a phase-locked loop (PLL) to extract the angle and the velocity of the rotating shaft. Check out the Resol...

2개월 전 | 0

답변 있음
how to connect universal bridge block to rotational electromechanical converter block?
Looks like the blocks trying to connect are part of two different technologies, Simscape technology (Rotational Electromechanica...

2개월 전 | 0

답변 있음
Simulation of Parallel Inverters connected in Island microgrid
A good place to learn about simulation of microgrid systems is Simscape Electrical and Simulink Control Design. Islanded Operati...

2개월 전 | 0

답변 있음
I want to connect 3-level power electronic device with demux which is connected to dq/abc subsystem
It is not possible to directly connect Simulink signals (dq0 to abc is a Simulink based block) to power lines of Universal Bridg...

2개월 전 | 0

답변 있음
MICROGRID BUILDING - sample time
This depends on how the model looks like. If there are PWM controlled converters then the simulation will be relatively slow, de...

2개월 전 | 0

답변 있음
finding sampling rate and real power
The first column is the vector of Time. It is easy to find the sampling rate by computing the change between two consecutive poi...

2개월 전 | 0

답변 있음
please help me to find a reference voltage to my converter
A good place to learn more about this kind of applications is Simscape Electrical. Check out the following example about Three-P...

2개월 전 | 0

| 수락됨

답변 있음
How can I use the 'Synchronous Machine SI Fundamental' block as a Motor mode in Simulink?
Yes, this is possible. This block models a synchronous machine in generator or motor mode using fundamental parameters in SI uni...

2개월 전 | 0

답변 있음
how to connect AC source to PMOS or NMOS
The blocks you are trying to connect are from two different technologies (Simscape technology and Specialized Power Systems). It...

2개월 전 | 0

답변 있음
How to get Power System Analysis Toolbox ?
Refer to this question on the same topic: https://www.mathworks.com/matlabcentral/answers/366652-how-to-get-power-system-analys...

2개월 전 | 0

답변 있음
how I can do the Rotor flux oriented control of the asynchronous machine on simulink??
Simscape Electrical has a few relevant example to learn more about asynchonous machine control. Three-Phase Asynchronous Driv...

2개월 전 | 0

답변 있음
Convert pulses into sine
This can be done using a Butterworth filter. More insights about the Butterworth filter can be found in Signal Processing Toolbo...

2개월 전 | 0

답변 있음
how to use light emitting diode in simulink ?
An example showing a LED driver based on a linear current regulator is available in Simscape Electrical: https://www.mathworks....

2개월 전 | 0

답변 있음
How to design a three-phase, three limbed multiwinding transformer ?
The Three-Winding Transformer (Three-Phase) block in Simscape Electrical is a good starting point: https://www.mathworks.com/he...

2개월 전 | 0

답변 있음
simulate diesel engine genset (synchronous generator)
Simscape Electrical includes a relevant example showing how to initialize and control a synchronous generator: https://www.math...

2개월 전 | 0

답변 있음
DC7 demo must work in 4 regions right?
The simulation captures only 3 quadrants but works well in all 4 quadrants. To see the operation in all 4 quadrants it would req...

2개월 전 | 0

답변 있음
simulink winding machine model
The Winding Machine is part of Simscape Electrical/Specialized Power systems. To access this block a license of Simscape Electri...

2개월 전 | 0

답변 있음
How to speed up simulation process
For this example, Ts=5e-6 which is needed because of the PWM generators. To simulate for a longer period the solution would be t...

2개월 전 | 0

답변 있음
Transformer parameters
To learn more about the three-winding transformer check the following resource in Simscape Electrical: https://www.mathworks.co...

2개월 전 | 0

답변 있음
IGBT Model in Simulink
A good starting point is the IGBT Characteristics example in Simscape Electrical: https://www.mathworks.com/help/sps/ug/igbt-ch...

2개월 전 | 0

답변 있음
In phasor simulation mode, is it possible to dynamically change the frequency?
The phasor technique gives the solution only at one particular frequency. Probably best to try fast restart if simulation at dif...

2개월 전 | 0

답변 있음
how to simulate the model of solar pv based grid connected multilevel inverter ?
A good starting point to learn about this kind of applications is the Three-Phase Grid-Connected Solar Photovoltaic System examp...

2개월 전 | 0

답변 있음
Reluctance Force Actuator for Electrical Motor
It is possible to use magnetic domain blocks to model electromechanical systems. Check the Faulted PMSM example in Simscape Elec...

2개월 전 | 0