Community Profile

photo

Delika Weragoda


Last seen: 3일 전 |  2021년부터 활동

Followers: 0   Following: 0

통계

  • Thankful Level 2

배지 보기

Feeds

보기 기준

질문


Heat transfer area in single and two phase pipe
Hi, Is there a method to change the heat transfer area in a pipe (TL) and pipe (2p)? The existing blocks consider the entire a...

대략 1개월 전 | 답변 수: 1 | 0

1

답변

질문


Modelling heat transfer from a solid pipe to a liquid flow
Hi, Is there a simscape block that represents the heat transfer from a pipe bundle (or a single pipe) directly to a cross flow...

11개월 전 | 답변 수: 1 | 0

1

답변

질문


Is there a way to switch between two thermal branches in a simscape model?
Hi, I'm trying to model a heat transfer scenario, during the initial transient state, there is convective heat transfer in t...

대략 1년 전 | 답변 수: 1 | 0

1

답변

질문


Solving ODE with boundary conditions
Is there a way to solve the following ODE with the boundary conditions? All other parameters A, B, C, D and n are constant...

1년 초과 전 | 답변 수: 1 | 0

1

답변

질문


Simulink - Simscape HTC input using model parameters
Hi, I'm trying to define a variable convective heat transfer coefficient using model parameters (i.e. temperature) in the simu...

1년 초과 전 | 답변 수: 0 | 0

0

답변

질문


Heat flow sensor data transfer from simscape to workspace
Hi, I'm trying to transfer the data from a heat flow rate sensor in simscape to workspace (time against heat flow data). I've ...

1년 초과 전 | 답변 수: 1 | 0

1

답변

질문


Is there a way to mark tangent lines on a graph plotted using the curve fitting app?
Hi, I've used the curve fitting app to plot a 2D graph using a set of data points. Is there a way to mark tangent lines on spe...

2년 초과 전 | 답변 수: 1 | 0

1

답변

질문


How to model a two phase pipe system under vacuum pressure?
I'm trying to model a two phase flow through a pipe network with an inital pressure (vacuum) of 3.5kPa. Two receiver-accumulator...

2년 초과 전 | 답변 수: 0 | 0

0

답변

질문


Is there a way to use a mass flow rate source and define the pressure differential across a closed loop two phase pipe system?
Hi, I'm trying to define flow through a two phase pipe using a mass flow rate source and to set the pressure differential in a...

2년 초과 전 | 답변 수: 0 | 0

0

답변

질문


Is there a way to model a pipe under vacuum pressure using Simscape?
Is there a way to model fluid flow in a pipe under vaccum pressure using simscape?

거의 3년 전 | 답변 수: 1 | 0

1

답변