UDP Transmit Multiple Example

This example shows how to transmit UDP data from an Arduino to multiple ports. The host desktop computer will be used to receive the UDP data.


Step 1: Deploy to the Arduino

The ArduinoUdpTransmitMultipleExample model uses two UDP Transmit blocks to transmit an array of uint8's to the host computer.

Use the following steps to deploy the model onto the Arduino:

  1. Open the model ArduinoUdpTransmitMultipleExample.slx
  2. If you are using an Arduino other than the Arduino Mega 2560, change the configuration parameters to match the board that you are using.
  3. Double-click on the UDP Transmit blocks and change the ip address and port number to match your network's configuration.
  4. Build the model by clicking the build button

As soon as the deployment is finished, the Arduino should be transmitting UDP data.

Step 2: Run the host script

The host script uses the udp functionality from the Instrument Control Toolbox to read incoming UDP data.

Use the following steps to read data on the host computer:

  1. Open the receiving function UdpReceiveMultiple_host.m
  2. Change the ip address and port number to match your network's configuration. i.e. h = udp('',8888,'LocalPort',8887,'TimeOut',0.1);
  3. Run this function to receive UDP data from the Arduino


Incoming UDP data tends to be blocked by a firewall. If you are not receiving any UDP data, you might have to configure your firewall to accept incoming UDP data or turn it off momentarily.