image thumbnail

Single-phase fully controlled converter for R loads

버전 1.0.0 (15.9 KB) 작성자: Vijay
Single-phase fully controlled converter for R with & without freewheeling diode using Matlab

다운로드 수: 165

업데이트 날짜: 2019/7/19

라이선스 보기

Single phase fully controlled converters are obtained by replacing the diodes of an uncontrolled converter with thyristors. It is one of the most popular converter circuits and is widely used in the speed control of separately excited dc machines. In a fully controlled converter the output voltage can be controlled by controlling the firing delay angle (α) of the thyristors. Thyristors T1 and T2 are fired together while T3 and T4 are fired 180º after T1 and T2. Depending on the load condition and the firing angle a fully controlled bridge converter can operate either in the continuous conduction mode or in the discontinuous conduction mode. In the continuous conduction mode, the load voltage depends only on the firing angle and not on load parameters. In the discontinuous conduction mode, the output voltage decreases with increasing load current. However, the output voltage is always greater than that in the continuous conduction mode for the same firing angle.

인용 양식

Vijay (2022). Single-phase fully controlled converter for R loads (https://www.mathworks.com/matlabcentral/fileexchange/72193-single-phase-fully-controlled-converter-for-r-loads), MATLAB Central File Exchange. 검색됨 .

MATLAB 릴리스 호환 정보
개발 환경: R2013b
모든 릴리스와 호환
플랫폼 호환성
Windows macOS Linux
태그 태그 추가

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!