MATLAB Answers

Create Variant object based on Configuration Reference

조회 수: 2(최근 30일)
Jonas 2021년 5월 26일
편집: Jonas 2021년 6월 1일
Hi all
I have a structure of models and model references, which all use the very same Configuration Reference object as their Configuration Parameters set. By changing the Configuration Reference, I can change the Configuration Parameters for all models at once. This Configuration Reference object and those Configuration Parameter sets are located inside a Data Dictionary, to which all models have access to.
I am using Variant Subsystems inside my models, and I want to make those variants based on which selection I make in the Configuration Reference object. (To which Configuration Parameter set I am pointing it to basically.) So I wanted to create a Simulink.Variant object, and as a condition I want to make a check of the Configuration Reference. For example, I want to see if the 'SystemTargetFile' is equal to 'ert.tlc'.
The problem I am having is how to write an expression for the Simulink.Variant object to get info from the Configuration Reference object?
I have used the following expression succesfully before:
but it requires to provide the model name as an argument. Since I need to use this Simulink.Variant object for all my models, I cannot provide the model name since it will be different many times.
I have tried the following expression:
but it cannot find the Configuration Reference object called 'Configuration_set', although the Variant object and the Configuration Reference object are inside the same Data Dictionary.

채택된 답변

Donn Shull
Donn Shull 2021년 5월 31일
Your variant expression cannot find your configuration object because variant object and the configuration object are in different Dictionary sections.
You could trysomething messy like storing a string with the name of your data dictionary in the 'Design Data' section:
thisDataDictionary = 'MyDataDictionary.sldd'
Then use an expression like
strcmp('grt.tlc', get_param('Configurations').getEntry('Configuration_set').getValue, 'SystemTargetFile'))
  댓글 수: 2
Jonas 2021년 6월 1일
Hi Donn, I found a command which can return the name of the Configuration set the Configuration Reference points to:
It returns 'Embedded'.
So I can use the following expression as a Variant expression:
to activate the variant for Embedded Code Generation.
Thank you very much!

댓글을 달려면 로그인하십시오.

추가 답변(0개)




Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by