Spectrum Analyzer sample rate.

조회 수: 6(최근 30일)
Paul Hamilton
Paul Hamilton 2021년 5월 9일
답변: Yoshi Minagawa 2021년 5월 21일
How do I change the sample rate of the spectrum analyser in a circuit? I cannot do this in either simulink or simscape. I keep getting an error that says it cannot open because the sample rate cannot be either continuous or zero.

답변(2개)

Pratyush Roy
Pratyush Roy 2021년 5월 12일
Hi Paul,
When you right click on the Spectrum Analyzer block and click on the "Properties" option, the following window will pop up:
After you click on the highlighted link, it leads you to the Spectrum Analyzer1 window which looks like the following:
On the top-left corner you can select Spectrum Settings(highlighted using Yellow) and then you can set the sample rate using the option as shown on the right (highlighted using Red).
Hope this helps!
  댓글 수: 1
Paul Hamilton
Paul Hamilton 2021년 5월 12일
This did not work. The sample rate box just shows Inherited and I cannot change it.
thanks though.

댓글을 달려면 로그인하십시오.


Yoshi Minagawa
Yoshi Minagawa 2021년 5월 21일
Hello Paul,
Please check the signal type of inport signal connected to Spectrum Analyzer Block. It must be a discrete signal. It is also written in the documentation.(see below)
If the signal is continuous and you want to change it to a discrete signal, please use Rate Transition block.(see below)
I hope this will help.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by