Hydraulic Actuators in Series
조회 수: 1 (최근 30일)
이전 댓글 표시
Hello,
I am trying to model two hydraulic actuators in series such that if actuator A expands by 2 inches, actuator B retracts by 2 inches.
The pic attached is what I have so far. Port A is from a hydraulic suspension and has varying pressures, but are all in the range of 1,000-10,000 psi. I think my issue is that since the C ports on both actuators are attached to ground and both R connections are connected, simulink thinks both actuators are in parallel and fighting together, rather than in series and fighting against each other.
Does anyone know a way to adjust this so the 2 actuators are fighting against each other?
댓글 수: 0
답변 (1개)
Yifeng Tang
2023년 2월 1일
There is a setting in the converter block about whether pressure in the volume causes the R port to move in positive or negative direction. There are a few example of a double-acting cylinder assembled this way in the shipping examples. Like this one:
Mimic its setup and you should be OK.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Upgrading Hydraulic Models to Use Isothermal Liquid Blocks에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!