필터 지우기
필터 지우기

Debugger not stopping on marker

조회 수: 4 (최근 30일)
Bob Thompson
Bob Thompson 2021년 3월 16일
댓글: Jan 2021년 3월 18일
I have a short code that I have put a debug marker in, before running it, but when it gets run the code moves past the marker and stops on an error. There isn't any logic that should cause it to skip over (I can move the marker seemingly anywhere in the code before the error and it still gets skipped.)
Anybody have any suggestions?
The code looks something like the following:
for ii=200:200:30000
command=['!systemcommand outfile.dat.' num2str(ii) ' 9.0932 0.0000 1.8288 > File.out'];
eval(command);
fid=fopen('File.out');
for jj=1:200
linep=fgetl(fid); % Crashes here.
if length(linep) >=2
if strcmp(linep(1:5),'T ')
T=[T;str2double(linep(6:end))];
elseif strcmp(linep(1:6),'taubeg')
t=[t;str2double(linep(10:end))];
end
end
end
fclose(fid);
end
  댓글 수: 6
Rik
Rik 2021년 3월 17일
Why use eval when you can avoid it? eval will never be faster and will always call attention. I would classify it as a code smell. It might not actually make a big difference here, but it will be interpreted as a sign that you either don't know or don't care about good coding practices.
Jan
Jan 2021년 3월 18일
@Bob Thompson: Avoiding EVAL is a good programming practize, not only in MATLAB, but as well in other interpreted langauges. MATLAB's code analysis cannot estimate the side effects of an EVAL command and therefore this command can have side-effects on the JIT acceleration although no variables have been defined dynamically.

댓글을 달려면 로그인하십시오.

답변 (1개)

Image Analyst
Image Analyst 2021년 3월 17일
Are you sure the file is saved before you try to set the breakpoint? I notice that if you stop at a break point, edit the code, and then try to set another breakpoint, it won't let you. And you can't save it while it's running or stopped at a breakpoint. You have to stop running completely, then save it, then set your breakpoint.
  댓글 수: 3
Image Analyst
Image Analyst 2021년 3월 17일
Call tech support and they'll do a screen-sharing session with you.
Bob Thompson
Bob Thompson 2021년 3월 17일
Thanks, I'll look into that.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 2-D and 3-D Plots에 대해 자세히 알아보기

태그

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by