Alternately zooming and editing a figure

조회 수: 4 (최근 30일)
Todd Welti
Todd Welti 2021년 3월 7일
댓글: Todd Welti 2021년 3월 31일
Has anyone found a solution to the problem that the edit model and zoom mode are mutually exclusive and buttons far apart? I spend about half my time zooming in and out and then going into edit mode and back into zoom mode. The edit button is all the way over on the left, and the zoom button is over on the right. I tried to set up a keyboard shortcut for switching edit-off-zoom-on, and the reverse but couldn't figure out how.

채택된 답변

Pratheek Punchathody
Pratheek Punchathody 2021년 3월 31일
편집: Pratheek Punchathody 2021년 3월 31일
As per my understanding, you are using the Zoom tool in the axes bar of the figure window and Edit menu from the menu alternatively. One work around to reduce the time of work during the switch between these two options is to enable the property inspector.
Following steps would help you to enable this,
View>Property inspector
By enabling this Property inspector will be populated along side of the Figure window.
Configuring and layouting the window according to the need will help you in minimizing the time to navigate between the edit and zoom mode.
Hope this helps..!
  댓글 수: 1
Todd Welti
Todd Welti 2021년 3월 31일
Yes, that is a possible solution. I need to familiarized myself more with that wind so I can find stuff quicker.

댓글을 달려면 로그인하십시오.

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Visual Exploration에 대해 자세히 알아보기

제품


릴리스

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by