How to Smoothen a rectified signal using Simulink blocks without Simpowersystems

조회 수: 5 (최근 30일)
Judith Orinda
Judith Orinda 2020년 12월 11일
이동: Sabin 2023년 1월 13일
I have this rectified signal and I would like to have an output that is a DC constant whose amplitude is the same as this input signal shown above. How can I do this using simulink blocks? without simpowersystems.

답변 (1개)

Mathieu NOE
Mathieu NOE 2020년 12월 11일
이동: Sabin 2023년 1월 13일
hello
simply use a low pass filter block (analog or discrete) and adjust the cut off frequency below the signal frequency

카테고리

Help CenterFile Exchange에서 Simulink에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by