MATLAB Answers

Error: "Each physical network must be connected to exactly one Solver Configuration block. There is no Solver Configuration block connected to Physical Network with the following blocks..."

조회 수: 99(최근 30일)
MTT79
MTT79 2020년 11월 4일
댓글: MTT79 2020년 11월 7일
I would like to Implement the following (see image on the left) Pulse Width Modulation (PWM) circuit on Simulink (see image on the right). However, i keep getting the following error:
"Each physical network must be connected to exactly one Solver Configuration block. There is no Solver Configuration block connected to Physical Network with the following blocks..."
Could someone help me out? Thanks!

답변(2개)

Joel Van Sickel
Joel Van Sickel 2020년 11월 4일
Hello,
the solver configuration block is a simscape block under utilities that you can connect to any part of your simscape network. It associates local solver settings for that simscape network since simscape uses more complex solver's than simulink does. You should be able to start with the default settings.
Regards,
Joel

Pemendra Kumar Pardhi
Pemendra Kumar Pardhi 2020년 11월 4일
Dear,
You have to recuired Solver Configuration block at grounding point as shown in attached file
the Solver Configuration Block can be obtained from
Simulink Library> simscape>foundation library> utilies
  댓글 수: 3
MTT79
MTT79 2020년 11월 7일
Thank you very much, Joel and Pemendra! You were both very helpful!

댓글을 달려면 로그인하십시오.

커뮤니티

더 많은 답변 보기:  Power Electronics Community

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by