MATLAB Answers

How can I properly set a valve with catalogues parameters?

조회 수: 1(최근 30일)
Lucca Martinelli
Lucca Martinelli 2020년 4월 6일
답변: Yifeng Tang 2021년 6월 18일
I am designing a simple hydraulic system with 4 way directional valve.
I looked in many catalogues do define the valve which I will use and the parameters are always a relation of Pressure and Flow, while the 4-Way Directional Valve block ask me for Maximum Area and Opening.
And if I change it to Pressure-flow characteristic I do not know how to set this vectors and matrix.
So how can I properly set my valve?
  댓글 수: 1
Yifeng Tang
Yifeng Tang 2020년 8월 17일
Hi Lucca,
To parametrize the pressure-flow curve or an area-vs-position table in the valve block, you'll likely need to use the "parameter estimator" tool from Simulink Design Optimization. This is usually the best option of you have too many parameters to be tuned by hand.
What method to use could also depend on what info, e.g. pressure-flow curve, is available from the datasheet, in my experience.

댓글을 달려면 로그인하십시오.

답변(1개)

Yifeng Tang
Yifeng Tang 2021년 6월 18일
Hi Lucca,
To parametrize the pressure-flow curve or an area-vs-position table in the valve block, you'll likely need to use the "parameter estimator" tool from Simulink Design Optimization. This is usually the best option of you have too many parameters to be tuned by hand.
What method to use could also depend on what info, e.g. pressure-flow curve, is available from the datasheet, in my experience.
In later releases of Simscape Fluids, some directional valves are pre-parametrized. For example: https://www.mathworks.com/help/physmod/hydro/ref/4way3positiondirectionalvalveil.html#mw_081f11e1-86cd-44fd-85d5-397155b41e93

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by