SOC estimation using UKF

조회 수: 12 (최근 30일)
sanya gode
sanya gode 2020년 3월 17일
댓글: nguyen 2023년 11월 14일
I am building a battery model to estimate SOC using UKF, my doubt is how to initialize Em, R and C values to enter in lookup tables also Capacity, Initial Charge Deficit and Cell dimensions for thermal properties. I know we need to initialize using m-script but the doubt is- I saw some example model on Mathworks but did not understand from where were those values taken. Was it some experimental data or specs from some datasheet ?
Kindly clarify.
Thanks in advance

채택된 답변

Pranav Murali
Pranav Murali 2020년 3월 27일
I can understand that you are interested in knowing how we arrived at the values of Em, R and C stored in the lookup table. In the example, Nonlinear State Estimation of a Degrading Battery System R0, R1, C1 and Em are 2D look-up tables that are dependent on SOC and battery temperature. The parameters in the look-up tables are identified using experimental data which was obtained from the publication given below:
Huria, Tarun, et al. "High fidelity electrical model with thermal dependence for characterization and simulation of high power lithium battery cells." Electric Vehicle Conference (IEVC), 2012 IEEE International. IEEE, 2012.
  댓글 수: 3
Christopher Francis
Christopher Francis 2022년 6월 10일
Hello Pranav, thank you for your answer. Thank you Sanya for asking. I have researched for the data file from the referenced publication but I am yet to find it. Could you kindly direct me as to how to go about getting it. Thank you!
nguyen
nguyen 2023년 11월 14일
can you share me your Simulink model please, i had a assignment but i did not finish.

댓글을 달려면 로그인하십시오.

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Propulsion and Power Systems에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by