how to plot a conventional DSB AM signal

조회 수: 3 (최근 30일)
Brigitte Hveding
Brigitte Hveding 2019년 12월 2일
댓글: Star Strider 2019년 12월 2일
Q: In MATLAB, make time-domain graphs of a Conventional DSB AM signal u(t) = A_c[1 + am(t)]cos(2×π×f_c×t), with A_c = 1, m(t) = cos(2×π×f_m×t), f_c = 1 kHz, f_m = 50 Hz, for four cases of AM modulations: a = 0, a = 0.3, a = 1, a = 1.3. Your graphs should be over four periods of the message (i.e., 0 < t < 4/fm). Include your code in your solution as well as the four graphs.
Matlab is not taught in this class but the TA thought it would be good practice for those who know it (which is most people but not me) Any help would be appreciated!

답변 (1개)

Star Strider
Star Strider 2019년 12월 2일
I am not certain how much help you need for this. For a start, see the documentation for the plot function. I am not certain if you are allowed to use it, however the modulate function could be helpful. It will at lelast make it easier for you to experiment. You likely need to clarify whether you are supposed to create a DSB-TC (transmitted carrier) or DSB-SC (suppressed carrier) signal, if this has not already been explained.
For a general introduction to MATLAB see the documentation section on Getting Started if you are completely new to it.
  댓글 수: 2
Brigitte Hveding
Brigitte Hveding 2019년 12월 2일
It has been specified as DSB-SC, sorry forgot to include that! he did not specify about not using the modulate function. Thanks for the links, I'll check them out.
Star Strider
Star Strider 2019년 12월 2일
My pleasure.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Directed Graphs에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by