SimBiology | simulation tolerance fails at beginning if time increased
조회 수: 1 (최근 30일)
이전 댓글 표시
I have built a model in SimBiology. I works fine say, if time is 1250 seconds. But it gives "Integration Tolerance Not Met" error at 10^-3 sec if time is increased to 1500 sec.
I am using "ode15s (stiff/NDE)" solver with default settings.
댓글 수: 0
채택된 답변
Arthur Goldsipe
2019년 6월 10일
편집: Arthur Goldsipe
2019년 8월 19일
My guess is that you are encountering the problem described in the tip on the AbsoluteToleranceStepSize reference page. The suggestion there is to update your simulation settings by manually setting AbsoluteToleranceStepSize to a small value. My suggestion would be to start with a value of 1e-5 and see how that works. If that results in the same error message, try 1e-6, and so on.
댓글 수: 0
추가 답변 (0개)
커뮤니티
더 많은 답변 보기: SimBiology Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Scan Parameter Ranges에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!