simulink TI C2000 F28035 Data monitoring

조회 수: 7(최근 30일)
Mustafa Ozsoy
Mustafa Ozsoy 2019년 4월 10일
답변: Yash 2022년 7월 14일
Hello all,
I am trying to drive a PMSM motor with Ti HV KİT. I have Piccolo 28035.
I am deploying the example simulink block(PMSM FOC) to DSP but, I need to monitor real time data at my PC.
I configrated model parameters. Configuration Parameters > Hardware Implementation > Hardware board settings > Target hardware resources > External Mode and set the communication type (serial) and Serial port (COMX).
After all this settings ı dont know how to read data.
We have been scratching our head with this so any suggestions would be greatly appreciated.
Thanks again,
Mustafa

채택된 답변

Yash
Yash 2022년 7월 14일
Hi Mustafa,
I understand that you are not able to connect to a suitable port for reading data. I suggest you to go to the host model and click on the data receive blocks, right click -> block parameter -> select the required port.
Hope this helps.

추가 답변(0개)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by