Invalid add-on library value - MKRMotorCarrier

Hi everyone,

I am just starting my first project (drawing robot) using the arduino engineering kit. Struggling to get past the first Task1 example which is to setup the board and run some commands. So thats the commands I am adding in.

Exercise 1: Introduction to the drawing robot

Connect to the hardware

Once you've set up the Arduino, you can connect to it from MATLAB. You can also connect to the motor carrier, which will be used to communicate with the other peripherals on the robot.

a = arduino;

carrier = addon(a,'Arduino/MKRMotorCarrier');

and when I do them, I get a

I tried looking at the libraries and list is screenshotted as well which shows there is a MKRMotorCarrier library.

Any suggestions as to what I may be doing wrong?

Kind regards

[Walter Roberson]

Is this replaced by https://www.mathworks.com/matlabcentral/answers/437799-installing-mkrmotorcarrier-and-arduino-libraries-failed-matlab-arduino-package ?

[Ahmet]

can you solve "Invalid add-on Library value 'Arduino/MKRMotorCarrier'. Valid libraries are 'Adafruit/MotorShieldV2'." this problem?