Simulink &TI f28379d ADC configuration

조회 수: 9(최근 30일)
tommaso serni
tommaso serni 2018년 11월 5일
답변: Yash 2022년 7월 7일
Hello everyone
I would like to acquire a signal from a current sensor (ACS712) using TI f28379d & Simulink, but I can not get a stable data from the ADC even using a constant and known voltage source.
Specifically, the sensor should measure the discharge current of a battery (2.5 A) by performing readings with a frequency of 10-100 Hz.
I attach the files used for the tests: Drive
Any ideas on how to configure the parameters to make a consistent reading?
Thanks, Tommaso.
  댓글 수: 1
SHAMSUL AREFEEN AL MAHMUD
SHAMSUL AREFEEN AL MAHMUD 2021년 4월 20일
Hello, did you able to get any solution for this issue? I am using the similar kind of current sensor and trying to connect with F28379D ADC. I ma having problem with configuring the ADC pin. I tried to get some values in ADC using software triggering but not working at all. I was giving 2 or 3 volts supply from a dc source.

댓글을 달려면 로그인하십시오.

답변(1개)

Yash
Yash 2022년 7월 7일
To get a stable output you can use a relay block available in Simulink. This may help you to get a stable value within the range you specify.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by