If i run PV model in matlab I have face this problem. Pls guide me how to solve this error. if I increase the time 1e-7 simulation is running but very slow.

조회 수: 7 (최근 30일)
An error occurred while running the simulation and the simulation was terminated Caused by: Simulink cannot solve the algebraic loop containing 'pv970kw/PV Array 1/Diode Rsh/Product5' at time 5.0E-5 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues. To rule out solver convergence as the cause of this error, either a) switch to LineSearch-based algorithm using set_param('pv970kw','AlgebraicLoopSolver','LineSearch') b) reducing the VariableStepDiscrete solver RelTol parameter so that the solver takes smaller time steps. If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification.
  댓글 수: 2
keyur acharya
keyur acharya 2018년 3월 28일
편집: keyur acharya 2018년 3월 28일
hi,were you able to solve the problem? if yes please share the solution. I am also facing the same issue.
Shashank Kumar
Shashank Kumar 2018년 8월 1일
Place a unit delay block in Simulink model between the blocks where algebraic loop occurs. I hope this will help you.

댓글을 달려면 로그인하십시오.

답변 (1개)

Shashank Kumar
Shashank Kumar 2018년 8월 1일
Place a unit delay block in Simulink model between the blocks where algebraic loop occurs. I hope this will help you.

카테고리

Help CenterFile Exchange에서 Schedule Model Components에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by